3M Edge Sealer 3950 1/2 Pint 8oz
This 3M Edge Sealer minimizes the adverse effects of rigorous use or prolonged or severe exposure conditions by providing water and contaminant-tight seal between a graphic film and substrate. It is required for some 3M warranted graphics (refer to the base film’s Product Bulletin for details). These products also may be applied even after the applied film shows signs of wear, such as edge lifting, to significantly reduce further wear; however, such an application does not meet the requirements for warranted graphics. The product can be used on decals as well.
- Do not apply edge sealer unless the temperature is above the minimum recommended temperature.
- Remove any application tape and re-squeegee the edges before applying the edge sealer.
- Make sure all edges to be sealed are clean, dry, and free of contaminants.
- To preserve the unused portion of the edge sealer, transfer the desired amount into a separate disposable container, and tightly recap the original container immediately. Leaving the original container open allows air to contaminate, reducing future shelf life.
- Do not thin the sealer.
- Use the dauber supplied with edge sealer or a 1/4 inch (0.6 cm) brush.
- Wipe any excess edge sealer off the dauber or brush.
- Hold the brush or the flat edge of the dauber so that it straddles the film and substrate
- Pull the dauber or brush along the edge in a smooth, continuous motion. Make sure the entire edge is covered with no gaps.
- Use opened and/or mixed sealer within two hours and discard any used sealer.
- Air dry for 24 hours before putting the graphic into service.
>
Carefully read and follow the manufacturer’s precautions and directions for use when handling solvents.
